Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 7/28/2005 8:28:54 AM EDT
I've gotten so used to the way my 1911s feel in my hand that the grips on my P226 feel too large. Does anyone make a grip that will make a substantial difference in the size. Any other suggestions? I like my P226 but want to get closer to the feel of a 1911 size grip. Thanks.
Link Posted: 7/28/2005 9:15:57 AM EDT
I personally don't know of any aftermarket grips that make the total grip size smaller. When I put Hogue grips on mine the grip was noticabley bigger.
Link Posted: 7/31/2005 5:57:42 AM EDT
BTT
Link Posted: 7/31/2005 11:11:17 AM EDT
Its a double stack, known for a wide grip... you are never going to make it feel anything like a 1911. I suggest a P225 or P220.
Link Posted: 7/31/2005 1:20:02 PM EDT
The original (checkered plastic) grips on the old P226s were SLIGHTLY slimmer than the current stippled grips. Every aftermarket grip I've seen for Sig has been noticeably thicker than the factory, not thinner...

Regards,

Kevin
Link Posted: 8/5/2005 7:19:26 PM EDT
[Last Edit: 8/9/2005 5:14:23 PM EDT by USARules]
The only grips that are as thin as the factory grips are Nills. They cost an arm and three legs but are top notchi
Link Posted: 8/5/2005 9:04:37 PM EDT

Originally Posted By USARules:
The only grips that are as then as the factory grips are Nills. They cost an arm and three legs but are top notchi



Source for these?
Link Posted: 8/6/2005 4:56:16 AM EDT
Link Posted: 8/6/2005 5:34:49 AM EDT
Thanks very much. Do you know of anyone in the USA that carries them?
Top Top