Quoted:
Why would you want to swap them for the 9mm4 follower? Are you having issues with the 9mm3 ones?
|
Well, I would intermittently have a cartridge jam on the feed ramp as it was coming out of the magazine. It occured 2 times within a 100 round shooting session with just one of the new LE marked magazines. I was shooting Winchester 115gr. FMJ value pack ammunition. I have not had a problem with the other hicaps I had purchased before the AWB sunsetting (same ammo, as well as other types). These were NFML Gen. 1 Glock factory 15 rnd. mags. I read on some other Glock forum that others were having the same problem with "9mm3" followers. I figured "What the heck, why not try the '9mm4' followers? These are after all, new magazines." I just wasn't sure if the "9mm4" followers would fit the LE marked mags. Thanks for your time!
|
Just so I'm clear: you experienced 2 failures using a NFML, Generation One, LE magazine that you just purchased in un-used condition?
I doubt you could install a 9mm4 follower in a Gen 1 NFML magazine but give it a try. The offical word from Glock is the 9mm4 followers will only fit mags that were made after June 2002. Is it possible that it's just a bad magazine? I would try a new mag spring first. If that doesn't help, paint the floor plate red and use that mag for failure drills
Also, what generation is the G19?