Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Site Notices
7/8/2020 3:01:36 PM
Posted: 11/27/2013 7:24:11 AM EDT
Hello,

I will soon be machined my glock 17 slide mount trijicon rmr.

I use trijicon sights for glock suppresor.

sights trijicon

I'm looking for the dimensions to shoot in co-witness.


thank you in advance.

Ben
Link Posted: 11/28/2013 4:59:28 AM EDT
The sight is supposed to be parallax free, so if you can see the sights through the window, you should be able to set the dot on top of the sights and have co-witness.
Link Posted: 11/28/2013 6:36:35 AM EDT
ok thank you.
But I must milling the slide and I don't have  measures.
Link Posted: 12/3/2013 2:57:17 PM EDT
Link Posted: 12/12/2013 12:22:04 AM EDT
[Last Edit: 12/12/2013 12:22:28 AM EDT by schristoph92]
Unless you are infinitely better at machining, specifically milling, than English I would suggest sending your slide out to get any work done. Otherwise I promise you will end up destroying a perfectly good slide, or blowing your hands up trying to make it work.
Link Posted: 12/12/2013 2:20:43 AM EDT
Link Posted: 12/12/2013 6:20:04 AM EDT
Maybe English is not a primary language.  Or he went to public school in the south.
Link Posted: 12/12/2013 7:19:08 AM EDT
You'd be better off getting someone with experience to do the milling (or buying a second pre-cut slide) and getting "gunsmith" sights that need to be filed down and then sending the filed sights to Tooltech for tritium inserts than trying to mill lower than is safe (or more accurately than practical) to try to get a perfect co-witness. Basic gunsmithing rule: file/cut the cheap part, not the expensive part.
Top Top