Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
Member Login

Site Notices
4/18/2021 9:59:29 PM
Posted: 6/2/2008 8:46:43 AM EDT
I picked up a new G21SF yesterday at the gun show. After nearly a year of looking I finally found the one with the Glock rail and single sided mag release!

I have not shot the pistol yet, but I can rack the slide, etc. and everything seems fine. However, when I disassemble the pistol and pull the slide off of the frame, the guide rod and spring always fall out. It is as if there is no spring pressure to hold it in place. I have the spring seated in the proper spot on the barrel and it does require some compression to get it into place. But for whatever reason, it is always loose when I remove the slide. My G19 doesn't do that, so I'm a little confused.

What gives?
Link Posted: 6/2/2008 11:37:05 AM EDT
Every G21 and G21 SF I have owned has done that.  The recoil rod gets seperated from the barrel when the pistol is assembled and is only set in the groove to hold it in place while the assembly is done.
Link Posted: 6/2/2008 6:31:32 PM EDT
Same thing with my G22, G23, and G20.  Its normal.
Link Posted: 6/2/2008 7:03:32 PM EDT
My G21 must not be normal....    
Link Posted: 6/2/2008 7:22:30 PM EDT
The same thing happens when I break my G-21 down. Even when I am using my Wolf barrel.
Link Posted: 6/3/2008 6:20:38 PM EDT

Quoted:
My G21 must not be normal....    
Same with my 21sf, 17, and 22.
Top Top