Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 6/11/2012 5:45:24 AM EDT
[Last Edit: 6/11/2012 5:49:53 AM EDT by sydney7629]
I was at a gun show this weekend and was really interested in one of these.

I understand that they arent meant for +P or high pressure loads. Are these guns OK with the target WWB that I normally buy for my more modern revlovers? I dont reload and hve no interest in getting in to reloading so I wanted something with ammo that was readily available.


Link Posted: 6/11/2012 10:58:52 AM EDT
Some of the real conversions of replica muzzle loaders are made for .38 HBWC. Some will shoot HBRN.
.45 LC version should be fine with Cowboy loaded bullets marketed for the SASS crowd. They irritate the heck out of me in my .45 LC lightning pump rifle because they have too much blowback/blowby. Need hotter round/powder to seal the cases in some carbines.
Reason enough to always wear shooting glasses.

If it is a .38 you can load Speer plastic bullets in plastic cartridges and shoot it for practice.
If it is a .45 you will need cases modified to use Rio or I believe Remington shotgun primers. Winchester and some others the primer will back out and fill the expanded primer hole and drag the cylinder too much.
Link Posted: 6/12/2012 6:21:18 PM EDT
First off, the 1872 Colt is not a conversion. It was a production open top cartridge revolver. It was not successful since the Army said they would not adopt an open top design, so Colt designed the 1873 SAA.

Now for the ammo. Every company out there makes some cast bullet .45 Colt loads. Any of those will be fine in the 1872. I reload for mine and have never put a factory round through it. But if I had to buy some factory loads for it, any standard pressure cast bullet load will be fine.

Another option out there is the replicas of the Richard Mason Conversion of the 1860 Army. I also have one of those, but that one is in .38 Special. It is a fun, soft shooting and accurate revolver.

The one big bonus of these over the SAA replicas is compensating for windage. With a SAA replica, you have to put the barrel in a vice and turn the barrel in the frame to lean the front sight one way or another to adjust the windage. You can pretty much plan on doing this if you get a SAA. Out of five SAA replicas that I own, only one came from the factory adjusted correctly windage wise.

Neither of my open tops were sighted in from the factory correctly for windage. The factory plans for this by leaving the rear sight extremely narrow, almost unusable. When you put it on paper, just use a small triangular file to enlarge the rear sight notch in the direction you need the bullet impact to move. It works equally well with the rear sight notch in the Richard Mason's hammer or the rear sight which is part of the 1872's barrel.

Basically, if you want a single action to use heavy loads or JHP defensive loads, buy a Ruger. If you will be happy with black powder equivalent cast bullet loads, pick one up. They are a lot of fun. I love mine.
Top Top