Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/28/2006 4:36:58 PM EST
I have a new Safariland 002 that is a little stiff to draw even with the screws backed out all the way. I'd like to bend it a bit to loosen and then use the adjustment screws as intended.

What is the best way to heat the kydex for this? Will steam work? Heat from a 1,200 watt hair dryer?

All advise appreciated.
Link Posted: 1/29/2006 6:08:55 AM EST
Hair dryer might work. I use a cheap heat gun I bought at an ACE Hardware store.
Link Posted: 1/29/2006 4:26:49 PM EST
Thanks Redbone. The wife had a 1600 watt hair dryer (not the 1200 I remembered) and it only took a couple of minutes to soften enough to do what I wanted done.
Top Top