Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 5/1/2002 7:21:49 AM EST
I have a new CZ 75 with non ajustable sights. It shoots a couple inches to the left, even from the bench rest postion.
The sights have no adjustments. Is there a way to adjust the sights? Do I need to bring it to a smith and have new ones installed?

Link Posted: 5/1/2002 7:55:30 AM EST
[Last Edit: 5/2/2002 9:52:49 AM EST by SGB]
You have to move the rear sight in its channel to the leftright slightly. Brownell sells a universal sight pusher in the $100 range that will do the job. You can also do it yourself with a brass punch and hammer.

I sandwich the slide between to pieces of smooth pine board and lock it down in a bench vise. Then use a brass punch and hammer to tap the sight to its desired location. Take care not to mar the slide or sight.

edited cuz sometimes I don't know my right from my left
Link Posted: 5/2/2002 7:58:00 AM EST
Drift rear sight to the right, but first make sure you are not pulling the shots. Maybe even let someone else try it to verify alignment. For some reason, I was guilty of pulling Glocks a little to the left at first. After use of a brass punch/drift, I use a Q-tip soaked with hoppes #9 to remove the brass mark.
Top Top