Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/17/2005 2:10:45 PM EDT
Anything Clean the stuff, its got years of dirt grease and junk on it.
Link Posted: 9/17/2005 2:21:36 PM EDT
Link Posted: 9/17/2005 2:32:28 PM EDT
Depends....... is it brushed, polished, clear coated ?

What kind of Al ? will make a difference, for good results
Link Posted: 9/17/2005 2:35:56 PM EDT
DO NOT use Simple Green!!!!! ( Corrosive torwards alu)
Link Posted: 9/17/2005 2:39:04 PM EDT
Link Posted: 9/17/2005 2:42:32 PM EDT
Mothers,
Link Posted: 9/17/2005 2:48:05 PM EDT
I'd spray 'em with Eezox and quickly wipe them down. That stuff is incredibe on guns too.
Link Posted: 9/17/2005 2:50:19 PM EDT
Woody Wax and bronze wool.

www.woody-wax.com/
Link Posted: 9/17/2005 2:51:49 PM EDT
Cast rough finish, its a transmission case from a car.
Link Posted: 9/17/2005 2:52:51 PM EDT
Link Posted: 9/17/2005 3:14:06 PM EDT
Best would be aluminum shot, but it's too expensive for a one shot deal, glass bead is fine.
Link Posted: 9/17/2005 3:20:48 PM EDT
Diesel and a stiff brush for the thick stuff. Spray it down with carburetor cleaner for a final clean.
Link Posted: 9/17/2005 4:04:40 PM EDT
I use Brightner (Safety Bright) that you get from places that sell and service car/truck washes. Spray on, let sit for 30 to 60 seconds and rinse with pressure washer.
Don't get the stuff with hydrofuloric acid unless you get the antidote also. It attacks the calcium in your bones or something to that effect and makes you feel like your on fire.
Safety Bright wont hurt you but it wont clean as well either.
Link Posted: 9/17/2005 4:48:19 PM EDT
If it's dirt and grease, first start with a bath of hot water and dish washing soap (the kind you use on plates, not on wimmenz).

Then to polish, Mother's works well.

First, you have to get your stuff clean, then polish.
Top Top