Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/24/2017 4:44:23 PM
11/22/2017 10:05:29 PM
Posted: 9/13/2004 3:24:06 PM EST
Anybody using this set-up? I'm concerned that the ergotek (padded) belt is too thick to go thru the belt slot on the ASP holder.

Brian
Link Posted: 9/14/2004 4:13:17 PM EST
Shouldn't be a problem. If the belt seems too thick to pull through the slot, just take the handy little hex wrench stored in the back of the scabbard & take out the screws holding the bottom of the clip to the body of the scabbard. Then slide the scabbard over the belt to where you want it to stay, then replace the screws & the back panel, & the scabbard should stay right where you need it, without having to use keepers.
Top Top