***UPPER # 1
reciever spoken for,
1/7 barrel assembly complete 155 [b]REDUCED to 135.00 SOLD PENDING FUNDS[/b]
colt bolt/carrier 110 *SOLD*
charging handle 10
This is a black, small hole, A2 upper with the feed ramp cuts and a “4" stamped over the gas tube.
It is mated to a 20" chrome lined gov’t profile barrel, marked C MP 5.56 NATO 1/7. The bayonet
lug has had the sides milled off for post ban use and a Kurts Kustom A2 tac brake has been
permanently installed. Then, it was refinished from the hand guards foward with flat black Teflon to
cover the milling marks on whats left of the lug.
This upper looks and shoots really good. The hand guards are a little rough though.
Pre ban, blue label all Colt upper. Small front pivot pin.
Grey Colt a2 upper with a Colt pre ban blue label 20" 1/9 twist barrel with no bayonet lug. Barrel
used to be an Hbar but KKF turned it down to the govt profile and reparked it. LIGHTWEIGHT UNDER THE HANDGUARDS.
This upper came on a mint Colt pre ban that was m4gerized. The barrel says;C MP 5.56 NATO
1/9 HBAR.( Now it is the gov’t profile and balances just right)
This upper is in like new condition with very few rounds fired. It has an extra hole drilled in the
carry handle to mount a 4X32 ACOG..
I’m asking 350.00 for the barreled upper
450.00 with the Colt half circle B/BC/CH
[b]**REDUCED TO 325.00 for upper and 435.00 for upper with B/BC/CH.**[/b]
[b]I have one set of night sights so I will install tritium night sights to either for 50.00 [/b]
shipping included to Con. U.S.
I can accept paypal or postal money order.
Email or IM for questions, Thanks, FRO