WTS the following:RRA 9mm A4 upper receiver <--SPF
This is a flat-top upper with the ejection port door and case defelctor. There are some minor marks on the case deflector from (you guessed it
) cases. There is also some minor finish wear on the rear take-down lug from where the DIAS engaged the lower. MSRP (based on RRA 2005 catalog) on this upper is $160. I'm asking $120.RRA 9mm bolt <--SPF to Aleko (a VERY understanding guy!)
This bolt has been ramped by M60JOE to eliminate trigger slap. This is considered by many an important modification. MSRP (based on RRA 2005 catalog) on this bolt (without the cost of the ramping) is $170. I'm asking $125.RRA mag block <--SPF
This is the one piece RRA mag block that accepts Colt or converted Uzi magazines. There are some minor scratches and marks on the bottom of the magwell from magazine insertion. The block installs into the bottom of any standard magwell and secures in place by a set screw. Again, this is a Colt-pattern block. It will hold open the bolt on the last round using Colt magazines, but not the Uzi magazine (unless the magazines are modified to actuate the hold open). MSRP (based on RRA 2005 catalog) on this block is $150. I'm asking $100.2 RRA 9mm hammers (not pictured)
Although not pictured, I have two NEW, NEVER USED RRA 9mm hammers. MSRP (based on RRA 2005 catalog) on these is $15 each. I'm asking $12.50.TROS-USA 9.25" barrel <--SPF
This is a 9.25" barrel. All NFA laws apply! This barrel must be used on a registered SBR or a registered full-auto! Asking $150.
Here are some pictures:
Here is a little history on these 9mm parts. I wanted a 9mm upper to run with my auto-sear. So, I built a quality upper using quality parts. It ran great in semi-auto, but wasn't exactly what I wanted for a full-auto 9mm. So, I selling off the pieces.
I had put around 1000 rounds through this before taking it all apart. I need to clean everything up, so sorry if some of it is a little dirty in the pictures.
All prices include shipping in the CONUS. I accept USPS MO and personal check; sorry no PayPal. Please let me know if you have any questions about any of this.
Best to contact me at firstname.lastname@example.org. Please include your ARFCOM screen name.
Thanks for looking!
edit to say barrel is SPF.
Edit to add comments (since I cannot "bump" my own thread by replying):
-bolt is in great shape. It does have some wear, after all I did put nearly 1000 rounds through the gun. I ran this with an M16 hammer only.
Edit to say only hammers are left. All else is SPF.
Edit to show updated status. Bolt is SPF to Aleko. (Thanks for ALL your understanding!) Mag block and upper are again available. Sorry to all for any inconvenience.
Edit to show upper is SPF.