See next post for trade details
For sale / for trade is my complete 16" mid length stainless steel barrel upper. It is chambered for 5.56 NATO. The entire upper, barrel and charging handle were professionally refinished in Norrell's SOCOM Black molyresin by John Norrell's head technician. The barrel is a 16" hbar with midlength gas system. The barrel has a 1/8 twist. It has an 11º target crown. http://ws04.ipowerweb.com/i101sexi/arfcom/mid1.jpghttp://ws04.ipowerweb.com/i101sexi/arfcom/mid2.jpg
Less than 300 rounds have been put through it. The barrel was cleaned immediately after each range trip. Cleaning has been done with an Otis cleaning kit using the coated wire to pull patches through.http://ws04.ipowerweb.com/i101sexi/arfcom/mid4.jpg
A mid-length picatinny rail (also refinished in moly resin) is attached to the handguards. It can be removed if desired using an allen wrench.http://ws04.ipowerweb.com/i101sexi/arfcom/mid3.jpg
A complete bolt assembly (bolt carrier, bolt, firing pin, etc.) is included.
The gas block is a weaver gas block.
Right now the spring on the ejection port cover appears to be on wrong. I will include all the parts necessary to replace this part (Ejection Port Cover Pin , Ejection Port Cover Retaining Ring , Ejection Port Cover Helical Spring ) although I think the spring is still ok to use, it just needs to be reinstalled. The ejection port cover is installed but it flops open instead of springing open.
The only other issue of note are some minor dings around the rear takedown pin hole.http://ws04.ipowerweb.com/i101sexi/arfcom/mid5.jpg
The upper and bolt are currently clean and lubricated.
I can furnish references (most notably 100% positive feedback on ebay) if necessary. Please email me at firstname.lastname@example.org
if you have any questions.I am asking $400 SHIPPED.
Thanks for looking!