FOR SALE: NEW IN THE PACKAGE - LDI PART#21459 - SPF
LASER DEVICES OPERATOR® series OP-6 EDTS
5-WATT LED TACTICAL FLASHLIGHT/WEAPONLIGHT
$70.00 or obo
(Open to trades - the light is $200+ New)
- MANUFACTURER OF THE DBAL-I, DBAL-A2, DBAL-A3, ETC.
· Waterproof to 20 meters
· Supplied with:
(2) 123A SUREFIRE Lithium Batteries
o 6 inch remote cable is supplied standard with pressure pad switches.
· Interchangeable tail cap assemblies available:
o Toggle switch
o 3-way (on/off/momentary) Toggle switch
o 3-way (on/off/momentary) Push Button switch
o Straight Wire Pressure Pad switch
o Coil Wire Pressure Pad switch
o Straight Wire Pressure Pad switch with Off (kill) Toggle switch
o Straight Wire Pressure Pad switch with On/Off Toggle switch
· Manufactured in the U.S.A.
· Optional Tip-Off Filters available in blue and red. Infrared filter available for incandescent lights only.
· Deeply knurled, non-slip grip
o Recoil-immune high intensity LED with Lexan lens provides 125 lumens of blinding white light––Over 30 times brighter than a standard high power LED
o Electronic Double Tap Switch (EDTS) End Cap. The EDTS has a remote cable port to allow quick and easy replacement of a broken or worn out remote cable assembly as well as a local activation switch located on the side of the end cap housing.
o In addition, the EDTS provides the following functionality:
Press and release either the remote cable switch or the local activation switch to operate the light in a traditional momentary fashion at the full brightness level.
Double tap the remote or local switch to activate the light continuously at full brightness. The light can be instantly returned to momentary activation by pressing and releasing either switch.
Press the remote or local switch three times and hold it down to decrease the level of brightness for map reading or situations where the full brightness level would be a disadvantage. The light will continue to operate at the reduced brightness level until either switch is double tapped which returns the light to full brightness.
Turning the EDTS end-cap approximately ½ turn counter clockwise provides a positive off position to prevent the light from being inadvertently activated by depressing the remote or local switch.
Diameter of Head
1.25 in. / 3.2 cm
Waterproof to 20 meters
5.9 in. / 13.4 cm
1 year on tactical light
3 years on LED illuminator
Anodized aircraft aluminum 6061T-6
4.6 oz. / 130.4 grams (with batteries)
LED: 1.5 hours continuous
Two 3-volt 123A Lithium
LED: High intensity light emitting diode
LED: 125 Lumens
I WON THIS LIGHT AT A TACTICAL CARBINE COURSE COMPETITION, IT HAS NEVER BEEN MOUNTED ON A WEAPON OR USED IN ANY CAPACITY.
TO VERIFY OPERATION I DID A FULL FUNCTION CHECK. THE LIGHT / REMOTE SWITCH OPERATE 100% AND THE 123A BATTERIES ARE FRESH.
THIS IS A GREAT LIGHT, MANUFACTURED IN USA BY A US MILITARY ELECTRONICS / LASER SUPPLIER.