Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/2/2002 2:01:54 PM EST
Specifically, what are the steps in the manufacturing process for each type of case-rimfire, centerfire, rimmed centerfire.
I'm mostly curious about how the base of the cartridge is made. Its easy to figure drawn brass but what of the thick part in the base?
Link Posted: 3/3/2002 3:27:07 AM EST
Your best bet is to do a web search or browse reloading/ammunition manuals. I've seen articles that do a decent job explaining it in two pages, with one page being a picture from blank stock to finishied case.
Link Posted: 3/3/2002 6:48:35 AM EST
[Last Edit: 3/3/2002 7:01:40 AM EST by warlord]
I have been to the factory of Starline Inc., www.starlinebrass.com/ when they were in Santa Fe Springs, Calif., about 10 miles SE of L.A. They have since moved to Sedalia, MO. I have seen them make 38SPL cases. They buy brass cups(1/2dia X 3/4 inch long) from Revere Copper and Brass. They use one of these cups to make each finished case. They feed these cups into a machine and out comes a 38SPL case on the other end.
OT:From all outward appearances there is no difffernce between a 38SPL and a 357Mag except for lenght, right? Wrong! The 357Mag case is heat treated for additional strength.

Starline in addition to their own brass, also is a subcontractor for Winchester, Remington etc. They have a drawer full of these headstamp dies.
Link Posted: 3/3/2002 1:36:05 PM EST
The best way to manufacture brass is to hammer brass slugs through a progressive series of dies until you reach the desired dimensions. The result is brass that is strong. As you can imagine, the equipment required is expensive. This process is only cost effective for very large production runs.

Another method involves turning brass from rod stock. This method doesn't yield brass as strong as the previous method. But it's more cost effective for producing small lots of obselete brass. I think Bertram uses this method.

As to your question regarding case head dimensions, I believe that's determined by the dies.
Top Top