Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/25/2001 11:08:44 AM EST
pretty much says it all
Link Posted: 11/25/2001 1:41:36 PM EST
Link Posted: 11/25/2001 2:37:42 PM EST
If I remember correctly, you will need a drift punch to remove the slide from the frame. There is a roll pin in the rear of the receiver for you to puch out. Call S&W for more info.
Link Posted: 11/25/2001 2:56:03 PM EST
[Last Edit: 11/25/2001 2:49:04 PM EST by Nick1950]
AR 18 is correct you should have received a punch with the gun when you bought it.
I hope you didn't buy it used. SW lists this gun with a very short life span. It is not made to practice with so don't expect to take it to the range and put a couple of hundred rounds through it.
Link Posted: 11/25/2001 2:59:40 PM EST
If you just keep shooting it, it may come apart all by itself.

Just kidding, yes, it should have come with a small pin punch to punch out the one take down pin. Don't punch it all the way out though, just far enough that the slide will move forward off the frame (learned this back when I had a Sigma 380).
Link Posted: 11/25/2001 6:11:33 PM EST
Thanks guys. My neighbor asked me to look at his gun and it was in need of a thurough cleaning. Upon taking it apart I see what you mean it is a piece of sh*t. I am going to recomend he replace it.
Link Posted: 11/25/2001 6:35:28 PM EST
Its a real bastard to strip. I had one, it was a real POS. It's made of some kind of zinc alloy it chews itself apart real quick.
Top Top