Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/23/2006 5:04:01 AM EST
I'm trying to remove the butt cap on my PTR-91 to install an E&L stock extension.

Anyone have a "simple" method to get the darned thing off, before I bugger it up with a screwdriver, mallet, or chain saw ???


Link Posted: 1/23/2006 5:15:33 AM EST
Put the buttpad in a vise and pull straight up on the stock, should come right off.
Link Posted: 1/23/2006 6:00:41 AM EST
+1 on the vise.
Link Posted: 1/23/2006 6:23:37 AM EST
The buttcap on my PTR91 was glued inplace. There are many site that you can buy a whole new stock and buttcap for very little. Sorry
Link Posted: 1/23/2006 6:27:15 AM EST

Originally Posted By arcticbear:
The buttcap on my PTR91 was glued inplace.

You're right... I need to stop thinking of these as HK's.
Link Posted: 1/23/2006 6:32:26 AM EST
"The buttcap on my PTR91 was glued inplace"

Meaning, you couldn't get it off w/ the vise method ???

Where's my chain saw ................................................. !!!
Link Posted: 1/23/2006 9:52:42 AM EST
As others said, the JLD buttpiece is glued in place and is not normally serviceable as a seperate part. Eh, it's cheap and required to meet the dumb 922 regulations.

Just buy a real HK buttstock with a removeable buttpiece. Then either use a padded vise or if you're ghetto like me, a wooden doorway/door and jam it between the door and door jam, then pull hard. (Or carefully use a screwdriver or padded Vise-grips and pry it off.)

Top Top