Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Page Armory » M-16
Site Notices
Posted: 6/10/2009 10:52:45 AM EST
[Last Edit: 6/10/2009 10:58:20 AM EST by Shermantor-AR15]
Umm, maybe this has been discussed before, but has anyone tried to use a AT-14, .410 cal shotgun upper receiver with at RDIAS? I guess the magwell is too small on a M16?

http://www.thefirearmblog.com/blog/2009/01/26/at-14-the-410-ar-15-shotgun/

It's made by Safir Arms
http://safirarms.com/eng.html

Link Posted: 6/15/2009 11:31:26 PM EST
[Last Edit: 6/15/2009 11:32:16 PM EST by Triangle-66]
If you look at breakdown video, the .410 upper has a lever in the upper that must be pulled all of the way down and out of the way of the bolt/carrier before it can be removed from the upper. It appears this is in the area where the tip of the auto sear would contact the bolt carrier and therefore preclude the use of an auto sear.
Link Posted: 6/16/2009 5:54:51 AM EST
the lever is infact in the way of the trip, but a few mins in a mill and you could open the upper receiver up to accept a Auto Sear, no idea if it would run. If it did work I'd buy 1 for my RR just to shot trap with for the novelty factor.
Page Armory » M-16
Top Top