Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/27/2001 6:24:56 PM EST
I'm trying to take my SAR2 trigger apart so that I can fix the trigger slap problem. can't seem how to get the parts out. There's a pin that runs through the disconnector, but it won't budge. I don't want to ruin anything, so I'm not gonna try it anymore unless that's what I'm supposed to push out.

Any ideas?
Link Posted: 10/27/2001 7:17:42 PM EST
The pins that hold the fire control parts in have a retaining clip to prevent them from falling out.

Usually it is a piece of music wire that holds both pins, you will find it on the inside of the receiver, almost flush against the side opposite the charging handle.
Link Posted: 10/27/2001 7:30:10 PM EST
Woohoo! Thank you! I never would have found that!
Link Posted: 10/27/2001 8:07:32 PM EST
Glad I could help!
Top Top