Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/26/2006 11:53:49 AM EST
[Last Edit: 2/26/2006 6:18:09 PM EST by Trainman]
Can someone roughly measure one in fractions? As in 1/2 in. or 9/16 in.

Link Posted: 2/27/2006 3:54:20 AM EST
Doesn't anyone have a basic 10/22 and a ruler? I did say rough measurement.
Link Posted: 2/27/2006 5:22:08 AM EST
What part of the bbl. do you want measured?
The bbl. is tapered you could get all kinds of measurements.
18 1/2 in long total, 17 3/4in. from rec to muzzle (minus shoulder that goes inside rec), 9/16in. o.d. at muzzle, and 15/16in. o.d. at rec.
What good are these in fractions? Making a stock?
Link Posted: 2/27/2006 8:22:00 PM EST
Thanks for the measurements. Sorry I wasn't specific about the location. I needed it at the muzzle. I'm looking for a .22 rifle to thread for a can, and gemtech recomends a barrel no smaller than 5/8 inches. That's for a .223 barrel, i'm sure 9/16 on a .22 is fine. Thanks again.
Top Top