Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/9/2006 8:20:55 AM EST
I notice on a web site you could modify a standard sear spring and roller to work in a semi pack. Anyone know how? Or anyone seen the semi springs for sale anywhere. Thanks.
Link Posted: 2/9/2006 8:57:07 AM EST
[Last Edit: 2/9/2006 8:59:20 AM EST by Dano523]
Link Posted: 2/9/2006 9:57:10 AM EST
[Last Edit: 2/9/2006 9:59:44 AM EST by j3_]
That's who I ordered the parts from. I was hoping there might be a pic out with them shown both ways.
Different question different post. Four days worth still on the first page anyway.
Still looking for a semi spring. Found a whole kit but was hoping for a single or two.
Link Posted: 2/9/2006 10:20:35 AM EST
[Last Edit: 2/9/2006 10:24:25 AM EST by Dano523]
Link Posted: 2/9/2006 10:37:53 AM EST
[Last Edit: 2/9/2006 10:38:30 AM EST by osprey21]
Interesting

Link Posted: 2/9/2006 11:01:50 AM EST
I guess anything I do will be an improvement over the way the old one was set up. I linked a picture of it in the other post.
Link Posted: 2/10/2006 8:25:36 AM EST
Link Posted: 2/10/2006 1:51:46 PM EST
[Last Edit: 2/10/2006 1:54:48 PM EST by j3_]
It is done exactly like the drawing you posted except the sear spring was done like the picture instead of adding a pin. Front cutout and welded trigger stop pin are already done to the drawing. The size of clip shelf piece welded in actually forces you to cut that large of an area off of the pack housing for it to fit in.
Top Top