Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 1/4/2012 5:09:29 PM EDT
I'm filling out my first Form 1 for an SBR AR and had a question about the Additional Description field on the form. I don't know how anal the ATF gets about this sort of thing but if I want to have my name and location on two lines on the lower like this:

NAME
CITY, STATE

Do I need to fill in the Form 1 Additional Description field with the information in 2 lines as above? or can I do it all in line like this: NAME CITY, STATE

I know this seems kind of nit picky but with the ATF one can never be too careful.
Link Posted: 1/4/2012 5:15:10 PM EDT
yes you can just fill it out in one line that does not matter at all

you just have to make sure that your info on the receiver is the same as on your form other than that you do not have to complete section H of the form.

Link Posted: 1/5/2012 1:27:56 PM EDT
Ok, one other question. I've been browsing the SBR pic thread and noticed that most people haven't engraved the side of the magwell. I had thought this was the usual place for them to be engraved. Where are most people putting them? Front of magwell? Top of trigger area?
Link Posted: 1/6/2012 12:44:12 AM EDT
The majoritythat I see are done in the most inconspicuous place availiable. Trigger guard, above the trigger pin, front of magwell etc. You have a lot of room to manuver, why not put it out of the way?
Top Top