Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 1/6/2012 5:39:40 AM EDT
My local gunshop had a bunch of lowers custom made for them from LMT and they have THEIR(my gunshops) logo's engraved on them. Their ugly as heck and I am going to be sending my receiver to Orion for SBR engraving and would like a custom logo put in place of the gunshop logo. My question is can I use say JB weld or Bondo to fill in the logo and still be able to have that spot reengraved?

Also before its said I AM NOT FILLING IN AND IDENTIFYING MARKINGS SUCH AS SERIAL NUMBER OR MANUFACTURER NAME OR ADDRESS.

Thanks,
Isaac
Link Posted: 1/6/2012 6:17:10 AM EDT
[Last Edit: 1/6/2012 6:18:00 AM EDT by Blitzkreig]
Ummm, no. Not going to be able to reanodize or engrave over bondo or JB weld.

ETA- best be would be to mill away the logo if you find it offensive and get the lower refinished.
Link Posted: 1/6/2012 10:04:02 AM EDT

Originally Posted By Blitzkreig:
Ummm, no. Not going to be able to reanodize or engrave over bondo or JB weld.

ETA- best be would be to mill away the logo if you find it offensive and get the lower refinished.


+1 Have it milled off.
Link Posted: 1/6/2012 8:41:16 PM EDT
Check Orion Arms website. They do offer fill in and re-engraving.
Top Top