I got the barrel from Pete-in-NH about 2 weeks ago and managed to get to the range last weekend and yesterday. (It's a 16" postban).
Since I had assembled the rifle, I was more concerned with making sure I had gotten everyting assembled correctly and that everything worked, rather than accuracy at this point. (All parts where RRA).
I've put about 500 rds through it (as of yesterday) without a single problem.
I used a variety of ammo, to test reliablity.
40 rds - XM193 55 gr (LC 2001)
200 rds - Korean 55 gr (P S 88)
30 rds - TZ (Israeli) 55 gr (TZ 87 & 88)
30 rds - Olympic SS109 63 gr (2001)
200 rds - Gualemalan (don't remember Headstamp)
30 rds - FN, FNW and other misc. junk.
Like I said, not a single FTF, FTE, or any problem.
I didn't fine tune the sights, yet, but found that I had to more the rear sight 1 click left, and the front sight still has plenty of room for adjustments. So, it appears that the front sight was properly installed and that the barrel was correctly indexed.
I did't bother to 'break in' the barrel as some people recommend. When I cleaned it, swabbed the bore with Shotters Choice and let it sit for a while, it only took a couple runs with the brush and about 4 patches to clean. There was evidence of copper fouling either.
I've very pleased with the entire rifle, and it appears that RRA did a great job with the manufacture of the barrel.