Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 3/18/2006 2:43:46 PM EDT
I just bought a wide handguard for my HK 91 clone and it is difficult to get it into position to put the pin in. I haven't forced it but was wondering if anyone had a similiar problem and what did they do to rectify the problem? Any help is appreciated. I just don't want to do something stupid and break the handguard. Thanks in advance!
Link Posted: 3/18/2006 2:55:33 PM EDT
If your barrel has a ring around it that is similar to that of the CETME, you may have to use a dremel to file down the ring in order for the handguard to fit properly. Check out cetmerifles.com for a sticky on handguard installation.
Link Posted: 3/18/2006 3:11:40 PM EDT
I will check out the CETME website you suggested. The rifle was built from an FMP kit if that matters. I really don't want to file on the rifle. If I am going to take any material off, it will most likely be on the handguard. Thanks
Top Top