Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 7/28/2002 7:45:43 AM EST
I am getting a new bushy m4 on weds. and want to know how you guys break-in your rifles. Any suggestions you have would be great. Thanks.
Link Posted: 7/28/2002 8:22:41 AM EST
I would strongly recommend giving it a good cleaning before taking it out. I didn't and had many FTE's and FTL's. After cleaning it, there hasn't been a problem since. When I broke it down, there was a sticky black sludge all over everything. It was so bad that the pin in the ejector wouldn't even press down until I had soaked it in CLP. After that, just have fun.
Link Posted: 7/28/2002 9:00:35 AM EST
Clean, lube/grease, and shoot.
Link Posted: 7/28/2002 9:31:56 AM EST
[Last Edit: 7/28/2002 10:33:50 AM EST by Big_Bear]
Link Posted: 7/28/2002 10:59:26 AM EST
Grease?
Link Posted: 7/28/2002 12:17:50 PM EST
CLP the hell out of the rifle apart (as much as the disassembly goes in the manual, let it sit for a little bit, clean all of it off, and then put a light coat on everything while putting it back together. Get the barrel itself completely dry though, it doesn't need a coat, and don't use a brush on it until you've fired a few hundred rounds.

After you get to a thousand rounds, you'll have worked all of the bugs.

My Bushy M4 came dry as a bone, and I've found the secret to the AR-15 is to keep it clean and well lubricated.
Top Top