Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/12/2006 1:48:10 PM EST
I want the barrel shortened, crowned and threaded on an original HK94. I understand this can be done with or without removing the barrel from the receiver -- without taking the barrel off it requires a sprcial tool. My question is, if it is removed are there likely to be any problems with re-instaling it? Also, anyone know who does this (both ways)?
Link Posted: 1/12/2006 2:42:19 PM EST
There are only a couple people who can do it with the barrel still in th eweapon. They have made a jig that holds things just right. Many other people can do it, but they must yank the barrel, do the cut-down, then put the barrel back in. That is a LOT more expensive, but it should end up just fine as long as you use a good HK smith to do it.

Check over on Subguns.com or HKPRO for a listy of smiths who can turn them down without yanking the barrel.
Link Posted: 1/12/2006 2:55:05 PM EST
Its either Mark @ARS or Derek @ AZEX that has built something just for theis purpose. I am pretty sure it is Mark.
Link Posted: 1/12/2006 3:20:26 PM EST
ARS has the ability to handle it.
Link Posted: 1/12/2006 4:42:04 PM EST
M60joe will do it for $118 delivered. Don't know about removing it, though.
pic from his website....
Top Top