Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/22/2020 12:12:56 PM
Posted: 11/21/2012 5:36:13 PM EST
Hey,

I am enjoying the new found speed with the bullet feeder hopper added. I was using the bullet feeder die with tubes and this is better. Had to position the whole thing on the bench to just make it between beams.

http://img20.imageshack.us/img20/2706/ammoplant.jpg
Link Posted: 11/21/2012 7:12:56 PM EST
Link Posted: 11/21/2012 7:22:33 PM EST
its a little tight but you can see the RCBS 1500 charge master for doing rifle, the dillon super wage, lyman trimmer, and other stuff behind the presses.

Thanks!
Link Posted: 11/21/2012 8:22:17 PM EST
Looks like a great set up there! I picked up a case feeder for my LNL AP and really like it, but haven't taken the plunge on a bullet feeder yet. Do you have any tips for someone considering a bullet feeder?
Link Posted: 11/22/2012 3:02:35 AM EST
The setup takes the most time for the bullet feeder. I like it alot though in the end. I can pay more attention to what is going on in the press now. I don't have to worry about feeding it anything and I can pay more attention to operation/powder/primers.
Link Posted: 11/22/2012 4:30:47 AM EST
Nice looking set up!
Link Posted: 11/22/2012 4:40:21 AM EST
Very nice!
Top Top