Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 2/1/2013 3:33:11 PM EDT
I have looked everywhere and found a few threads with no answers. What size dovetail / dovetail cutter is on the glock for rearsight? Thanks.
Link Posted: 2/4/2013 6:09:19 PM EDT
They are different for the different sized frames. They are also beveled with the center a smaller size than the outside. sights are not a hammer in to make fit. Most need to be filed to make a perfect fit.

I just put some Trijicons on a glock. You-tube helped a lot.
Link Posted: 2/27/2013 2:02:43 PM EDT
The rear sight dovetail is the same across all Glock models. The rear sight height is some what model specific. I have been looking for the Glock factory spec and have not found any thing. I know one of the major manufacturers of third party Glock slides and he was purposefully unclear when I asked him rear sight dovetail cutter. Like it's some big secret.

I believe I have figured out. The Glock dovetail is essentially a .250" x 74° dovetail, cut ~.079" deep. In metric that works out to 6.4mm x 74°, with a depth of 2mm. I just cut a test dovetail in a piece of 3/4" 7075 bar stock and it is a perfect fit for a take off Warren Tactical rear sight I have.

Tallamong is correct that Glock uses a pinched profile in the dovetails cut on their slides. However, when cutting a dovetail to use a Glock rear sight it is not necessary to copy Glock's pinched profile. A conventional, straight cut to fit dovetail will suffice. And I feel is preferable.
Top Top