Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 9/17/2002 10:35:25 PM EST
Does anyone make a weaver rail scope mount for the Garand?
Link Posted: 9/18/2002 4:46:47 AM EST
[Last Edit: 9/18/2002 4:47:29 AM EST by raf]
Link Posted: 9/18/2002 5:13:19 AM EST
I have the B-Square mount on one of my Garands, the one with the NM barrel and op rod. It works quite well.
Link Posted: 9/18/2002 5:22:32 AM EST
Link Posted: 9/18/2002 6:56:40 AM EST

Originally Posted By raf:

Originally Posted By LARRYG:
I have the B-Square mount on one of my Garands, the one with the NM barrel and op rod. It works quite well.



LARRYG, can you describe how the mount and scope attach to the rifle? How is the loading of clips and the ejection of same and brass impacted? Can the iron sights be used preferably immediately and without dismounting the scope? Is a cheek pad needed to provide proper cheek weld to the stock?

I'm curious.



Unfortunately, you have to remove the rear sight. It is canted off to the side and loading and ejection are no problem. You won't need a cheekpad because it is canted to the left.

I have 3 Garands and have this setup on one of them. I plan on being far enough away that I can switch to one of the other Garands or an AR if need be.
Link Posted: 9/18/2002 9:03:53 AM EST
[Last Edit: 9/18/2002 9:09:02 AM EST by QBit]
Perhaps I should have specified.

A scout-rifle type mount. Perhaps replacing the top wood just forward of the reciever.
Link Posted: 9/18/2002 2:04:09 PM EST
Top Top