Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/24/2005 2:38:41 AM EDT
I have a G3 clone I'm trying to refinish. I would like realign the triple frame, but can't figure out the best method for pressing it off. I understand it's soldered to the barrel which is easy enough to heat loose, but that sucker is pressed on the knurled part of the barrel TIGHT.

Any one have plans for a home-made jig? Block of wood and a hammer? Any suggestions are appreciated...I'm at a loss.

Thanks
Link Posted: 9/24/2005 10:40:41 AM EDT
[Last Edit: 9/24/2005 10:41:17 AM EDT by Dano523]
If you have pulled the front sight sling hook (it seconds as a band cross pin), then once heated the band should be able to knocked forward with a leather mallet (only if the band was soldered and not brazed/welded on).
Top Top