Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
PSA
Member Login

Page Armory » Blades
Site Notices
7/8/2020 3:01:36 PM
Posted: 4/28/2011 5:48:52 AM EDT
I made this one from 01 but I am considering 1095 because it's a bit more forgiving during the heat treat phase.  What do you think of using carbon fiber for the pins and tube?  Thanks in advance for the feedback.http://www.bushmonkeyknives.com/IMG_0955_op_768x586.jpg
Link Posted: 4/28/2011 6:11:32 AM EDT
That looks pretty awesome, good work!!!
Link Posted: 4/28/2011 9:40:21 AM EDT
Thanks for the compliment.  I have made quite a few of these using G10 and micarta.  This was my first one in a bright color as I usually use earth tones and OD.
Link Posted: 4/28/2011 11:23:10 AM EDT
I think the CF pin and tube are a nice touch too.  Alot of times bronze or silver pins can take away from the knife's scales and actual blade.  I dig it !
Link Posted: 4/29/2011 12:52:37 PM EDT
I just had 50 blanks cut out on the waterjet cutting machine and will try some G10 pins and spacer material as well - thanks again for your comments.
Link Posted: 4/30/2011 6:23:53 PM EDT
Blue g10 is awesome!
Page Armory » Blades
Top Top