Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 11/1/2001 8:53:05 AM EDT
Gun shop guy said they would'nt.
Found a good price but I wont order till
I check with the experts(you guys).
Link Posted: 11/1/2001 8:54:44 AM EDT
You'll have to use the dremel tool on the little ridge, but they work fine after being buzzed.

Mike
Link Posted: 11/1/2001 9:44:12 AM EDT
Link Posted: 11/1/2001 9:46:19 AM EDT
I have some that do work and some that do not work. It is that ridge on the mag that causes the problem. You would to to lower the ridge to have it accepted into the Bushy's mag well. There are some Orlites that have a lower ridge that will accept into the mag well.
Link Posted: 11/1/2001 1:42:15 PM EDT
I had some that didn't work, but they do now. It is not really the mags problem it is the lower, or should I say the mag well.

The angle around the mouth of the mag well was not cut back enough. I fixed the problem on the lower by increasing the depth of the angle to let the mags fit. I myself want the gun to fit any mag, not have to make every mag fit the gun.
Top Top