Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 8/14/2018 12:31:19 AM EDT
As the title says, do I need to pin the flash suppressor to my barrel before I change out the pads to prevent creating an unregistered SBR while it doesn’t have a butt pad on?
Link Posted: 8/14/2018 1:04:10 AM EDT
WTF
Link Posted: 8/14/2018 1:31:23 AM EDT
You are concerned with OAL not barrel length.

It must be 26 inches
Link Posted: 8/14/2018 2:21:29 AM EDT
Originally Posted By AzAgLover:
As the title says, do I need to pin the flash suppressor to my barrel before I change out the pads to prevent creating an unregistered SBR while it doesn’t have a butt pad on?
View Quote
Measure it if you want to be sure.

But given that you’re disassembling it to add new parts I would venture to say no.
Link Posted: 8/14/2018 2:57:53 AM EDT
Id say no it’s disassembled at that point. If you are really paranoid about it pull out the bcg and barrel assembly before hand until the swaps over not like it can operate like that and when it’s put back together it’s going to be over 26”.

If you are going to pin and weld anyways you might as well go for the slim buttpad instead of the manticore one.
Link Posted: 8/14/2018 6:24:18 AM EDT
[Last Edit: 8/14/2018 6:25:04 AM EDT by Manticore_Arms]
Top Top