Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/30/2006 5:08:00 PM EST
I can't figure out how the end result will be different. How will each one looks when finished building with a kit? I can only buy one. Thanks in advance for your help.

Link Posted: 3/31/2006 3:42:05 AM EST
Ok,

The quick lowdown.

Type I's(Metric/Euro) are the original of course. Metric mag notched, and have a uninterupted scallop/notch that runs along the lower edge of the upper receiver.

Type II's(Metric/Euro)have a different scallop/notch profile that left a lil more metal where some receivers were cracking under severe punishment from sustained full auto firing. Offers no real benefit for semi auto guns.

L1A1's(Commonwealth/Inch) look most like type I's but, are cut for Commonwealth/Inch patter magazines, have sand cuts internally that help spit out crud(when used with a sand cut bolt carrier), and have a minor change to accomodate the std folding cocking handle.

If you have a commonwealth kit, I'd go with the L1A1 since DSA is now making those to keep it closest to original config. If you have a metric( IMBEL, DSA, Coonan, etc.)kit, I'd stick with a Type I but, that's a personal preference.

FYI-DSA's type I's can be had without the carry handle notch for those who think carry handles are stupid(might also add a bit more rigidity to the receiver)

HTH

Blitz
Link Posted: 4/1/2006 1:54:20 PM EST

Originally Posted By Blitzkreig:
Ok,

The quick lowdown.

Type I's(Metric/Euro) are the original of course. Metric mag notched, and have a uninterupted scallop/notch that runs along the lower edge of the upper receiver.

Type II's(Metric/Euro)have a different scallop/notch profile that left a lil more metal where some receivers were cracking under severe punishment from sustained full auto firing. Offers no real benefit for semi auto guns.

L1A1's(Commonwealth/Inch) look most like type I's but, are cut for Commonwealth/Inch patter magazines, have sand cuts internally that help spit out crud(when used with a sand cut bolt carrier), and have a minor change to accomodate the std folding cocking handle.

If you have a commonwealth kit, I'd go with the L1A1 since DSA is now making those to keep it closest to original config. If you have a metric( IMBEL, DSA, Coonan, etc.)kit, I'd stick with a Type I but, that's a personal preference.

FYI-DSA's type I's can be had without the carry handle notch for those who think carry handles are stupid(might also add a bit more rigidity to the receiver)

HTH

Blitz




I thought type 1 receivers are stronger?!
Link Posted: 4/1/2006 3:32:47 PM EST
Negative Groundfire, negative
Top Top