Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 8/28/2002 4:28:16 AM EST

I'd really like to get a remington factory folding stock finished to match the marine magnum, but I don't want a hack job that doesn't match, or worse, peels.

And yes... I called Remington, and was told it was proprietary information.

Thanks in advance for any help or recommendations... Brian
Link Posted: 8/28/2002 7:27:07 PM EST
[Last Edit: 8/28/2002 7:28:23 PM EST by WillieD]
This is only speculation based on one conversation 3 years ago. It is/was Klein Plating in Erie, Pa. I was interested in getting a SIG redone and Klein was a sub-contractor for SIG. When I called them they asked first if I had a SIG or Remington so they would give me the right department/armoror when I told them I had a firearm to refinish. I know for a fact that SIG no longer uses them due to overplating of slides causing FTE/FTF between the slide and barrel. Hope that was some light. I personally recommend Metocol III from Arizona response systems. He can match almost anything.
Top Top