Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/15/2003 8:13:09 AM EST
How do I remove the cap at the end of the magazine tube? Not the one that screws off, but the one that holds the spring in?
Link Posted: 11/15/2003 8:24:03 AM EST
The spring retainer slides in with a friction fit.

Just stick a cleaning rod or a small screwdriver into the hole in the center and pull it out.
Link Posted: 11/15/2003 8:35:01 AM EST
Watch out when you pop that retainer loose. That spring is gonna fly out of there!!!!
Link Posted: 11/15/2003 8:11:21 PM EST
Stick a screwdriver in and push it down about 2" then turn it a quarter turn in any direction and slowly release it.

This will work if you have a dimple on the underside of your mag tube. If you are sticking an extension, you should drill out the dimples with a 5/16" drill bit or do what I did and take the dremel and sand them down then clean out the whole tube from the metal particles.
Top Top