Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 5/9/2004 6:49:40 AM EST
Ok, I'm sure it's somewhere on the site but after searching for 15 minutes I grew impatient. How do I take off my collaspable? Do I need a special wrench? Trying to put on a GG&G single point adapter. Thanks.

Leo6223
Link Posted: 5/9/2004 6:54:59 AM EST
If it's a Colt, you will need to remove the stake on the retension nut/receiver.

As for tools, just need a carbine tool to spin the retaining nut just behind the receiver. The receiver extension will spin by hand after the retension nut is loosened.

Also, if the receiver extension/retension nut was installed with loctite, you will need a heat gun to break the bond.
Link Posted: 5/9/2004 7:29:54 AM EST
Link Posted: 5/9/2004 8:19:18 AM EST
The older nut has holes, the newer ones have indents like a castle, the wrenches for them are different. As to the stake, I've not seen one, usually a wrench will do the job.
Top Top