Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/5/2003 7:20:48 PM EST
[Last Edit: 11/5/2003 7:43:32 PM EST by armax]
I just purchased a stock and noticed that the plastic nub that goes into the back of the reciever has a small circle in the center that looks like something like a plastic pin is broken off. Is there supposed to be something coming out of the center of the nub or is it just a manufacturing finish flaw?
Link Posted: 11/5/2003 7:27:24 PM EST
Pardon my ignorance, but are you talking about the nub on the stock that goes into the rear of the receiver or the takedown pin detent itself?
Link Posted: 11/5/2003 7:32:23 PM EST
yep, I was just about to edit my post from pin to nub.
Link Posted: 11/5/2003 7:54:29 PM EST
Ah...you're fine dude! It's just a by-product of the molding process. The detent spring actually sits to the side of that nub.
Link Posted: 11/5/2003 8:23:43 PM EST
thank you much bradd! you set my mind at ease.
Top Top