Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 6/16/2003 11:37:39 AM EDT
I bought an ace stock for my Daewoo and I needed to replace the hammer, trigger and disconnector with the parts they supplied. I got the disconnector and the trigger in but I am having difficulty with the hammer. The pin that seats the hammer does not seem to want to go through the hole on the hammer (I checked the old hammer and it's the same- won't go through). Is there a trick to getting the pin back through the hole or do I need to exert a little more force. The pin came out very easy.
Thanks
Link Posted: 6/16/2003 12:48:15 PM EDT
No problem. I was able to figure it out. Rotating the selector to semi allowed me to press down and align the trigger up properly. Whew! Next time it will be old hat.
Top Top