Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/25/2002 1:34:05 PM EST
[Last Edit: 11/25/2002 1:37:44 PM EST by bravo2]
What are you using to paint the "fire,safe,numbers on flattop,bm symbols and etc." I seen red,yellow, and white ones done. What are you using? How easy is it with out messing up?
Link Posted: 11/25/2002 2:11:53 PM EST
Use crayons, seriously!
Link Posted: 11/25/2002 8:00:20 PM EST
Porcelain paint.
Link Posted: 11/26/2002 9:41:56 AM EST
For white, or off white numbers, I use refrigerator touch up paint. Comes in a small bottle, with an applicator brush. Paint the lettered area fully, let it dry, then clean the overage off with a rag soaked in lacquer thinner. Works for me! [:D] By the way, when I did this to my Bushie, the emblem and lettering came out very unattractive looking. It's cut too deep or too wide, or something (???) Anyway I cleaned it off by scrubbing w/a lacquer thinner soaked toothbrush, and it's my only AR without white markings and lettering. Only mention this so you won't be surprised if you don't like what you get w/your Bushie. My Colt and Rock River units look just fine w/the stuff.
Link Posted: 11/26/2002 9:55:48 AM EST
thin paint brush and testers model paint. Use a paper towel with clp on it to take of excess. just a dab of clp then wipe over the letters works great. Used this to do the safe and fire on my rifle.
Link Posted: 11/26/2002 10:11:58 AM EST
Thanks mostly wanted to do safe,fire and the numbers on varminter flattop. Do my BM m4 too.
Link Posted: 11/26/2002 10:55:06 AM EST
Won't Gunscrubber eat off the model paint?
Top Top