Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 7/3/2003 2:40:54 PM EST
I have a bsquare handle mount on my bushmaster. I just bought weaver-style angle-loc windage adj rings. I am having trouble following the instructions. It seems a lot more complicated than just slapping them on and tightening them up. Any hints to installing them and also playing with the windage settings at the range.
Link Posted: 7/3/2003 2:56:35 PM EST
[Last Edit: 7/3/2003 2:57:23 PM EST by OldTiger]
When the gun shop mounts mine, he backs the screws off equally and tightens an equal amount when he has them installed. I normally do windage in the scope, and don't mess with the rings. (He has also checked the scope to insure its adjustment knobs are centered before boresighting it.)
Link Posted: 7/3/2003 3:20:29 PM EST
OldTiger is correct on the equal pressure method. Unless you have done it a few times you have a greater chance of marring the tube than adjusting for windage. I like the Leupold Weaver style rings but they are a bit pricey compared to Millets. [:)>]
Top Top