Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 4/9/2006 12:59:48 PM EST
[Last Edit: 4/9/2006 1:00:29 PM EST by ops144]
use the carrier and bolt or do i need a new one for a new barreled upper?

i did a search and found a little bit of info but not alot..

the bolt and carrier have only about 500 / 700 rounds through it...

if i can get away with reusing the carrier and bolt i would like to..

its an armalite m15a2 middie "kickin my self for not getting a flat top"


thanks for the info in advance
Link Posted: 4/9/2006 1:05:08 PM EST
double check it, just like any part after installation and use it.
Link Posted: 4/9/2006 1:09:41 PM EST
If your using the barrel from your A2 set-up on your new receiver, then yes. If your buying a whole new upper and using the old bolt from the A2, then yes, but....................you MIGHT wan't to get the headspacing checked. With a round count as low as 500 / 700 your probably safe. But better safe than sorry.
Link Posted: 4/9/2006 5:21:04 PM EST
thanks guys

how do ya check head space??

thanks again
Link Posted: 4/9/2006 6:47:49 PM EST
Link Posted: 4/11/2006 7:44:18 AM EST
no i will be getting a barreled upper if i do it
Link Posted: 4/11/2006 9:01:28 AM EST
[Last Edit: 4/11/2006 9:06:54 AM EST by guam50]

Originally Posted By Stickman:
If you are using the same bolt and barrel, there is no need to check anything, its imposible for the headspace to change. If you are just swapping uppers, you are good to go.



+1. Changing the upper receiver would be a cheaper alternative to buying a new BCG, if you had the tools to do it. You can sell the A2 receiver here and make your money back. Or you can just buy a new bolt if you want and use your existing carrier if your getting a new complete upper (also a cheaper alternative to buying a whole new BCG).

You check headspace using "GO, NO GO," and FIELD" gauges. From what I've read, people here argue about which gauge to use. I have all 3 of them and use each one just to make sure.

ETA: .
Link Posted: 4/11/2006 10:01:28 AM EST
I understand the go should close on the guage.
no-go shouldn't close on the guage.
what does a field guage tell you?
Link Posted: 4/11/2006 8:12:11 PM EST
[Last Edit: 4/11/2006 8:17:41 PM EST by engineer2001]
Mosin Nagant headspace page


If a rifle closes on a NO-GO gauge but not on a FIELD gauge (below) the rifle is considered safe to fire using factory new ammunition, but not safe to fire using reloaded or used cartridge cases.


Top Top