Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/27/2006 4:21:03 PM EST
This is my first install. I can't get the trigger to line up with the holes. It feels like it "bottoms out". I have a hogue grip. The safety turns, but seems loud. Help a noob out?
Link Posted: 3/27/2006 5:10:50 PM EST
Um.. once long ago I though I read that the pistol grip screw can protrude too far into the receiver inards and press against the..something?
Link Posted: 3/27/2006 5:45:14 PM EST
The screw does not go all the way into the receiver. Thanks though.
Link Posted: 3/27/2006 9:43:24 PM EST
I noticed in one of my RRA builds, with the same trigger, that I had to take off the selector switch before installing the trigger assembly. To reinstall the safety, you have to cock the hammer as far down as it will go, hold and slide the selector back in.

You will have to take off the pistol grip stock to remove the selector. Be careful of the selector spring and detent.

Hope this helps.
Link Posted: 3/28/2006 2:47:11 PM EST
Thank you for your help. The hammer spring was incorrect and the trigger would not fit. Everything together now!
Top Top