Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 1/6/2005 10:33:00 AM EDT
I have a new dissapator that is shooting 14 inches high at 25 yards. I have the front sight post down as far as it will go, the rifle groups well, but I dont' have enough front sight adjustment to bring it down. anyone have any ideas or had this happen to them.
Link Posted: 1/6/2005 11:56:22 AM EDT
you rase the front sight to lower your point of impact.

the front sight works just the opposite of the rear sight.

you should have more than inough adjustment to bring it down.

rotate the front sight untill the top of the base is level with the top of the front sight base. Go from there.
Link Posted: 1/6/2005 10:56:03 PM EDT
i was gonna say the front sight goes oppisit of the correction you want to make. lower the point of impact raise the front sight. raise the point of impact lower the front sight. at least this way all you have to do is aim center mass to make head shots.lol just kidding.
Link Posted: 1/7/2005 1:18:34 AM EDT
Link Posted: 1/7/2005 9:46:54 AM EDT
I put "down" but I meant up. I have moved the front sight "up" past the point where the detent ball is catching, and it is still fourteen inches high. I have never had this problem on any other AR I've owned. Thanks for the replies though.
Link Posted: 1/7/2005 3:17:29 PM EDT
hmm

is the rear sight all the way down. If its a detachable carrying handel make shure its seatted flush and not cocked.

Are there copper streaks on the Flash Suppressor any where. is the crown in good shape.
What type of ammo are you using?

is the barrel bent?
Link Posted: 1/7/2005 11:39:32 PM EDT
Top Top