Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 9/18/2003 10:36:49 AM EST
Will the ammonia based products used for copper fouling remove copper oxide as well?

Thanx
Link Posted: 9/18/2003 6:51:46 PM EST
Where do you have copper oxide ?
Link Posted: 9/18/2003 8:27:09 PM EST
If copper oxide is the same as the brownish patina on a penny – then yes. If it isn’t, I haven’t a clue! [:D]
Link Posted: 9/19/2003 5:54:58 PM EST
Two "easy" ways to check for copper of any kind (including most oxides) is to either see if your patch comes out green after the suspected copper oxide has been exposed to one of the higher concentration bore cleaners (make sure not to use any copper containing brushes). The second method is to take a small scraping and put the flake in one's scanning electron microscope [;)]. While of course I am being a little bit of wise ass ... could always be talked into a little free anlysis for any interesting project (assuming lab stays together).
Top Top