Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 3/19/2006 7:14:06 PM EDT
I installed a PRI Big Latch, and noticed that after a while the roll pin I used to install the Big Latch keeps creeping up or down out of the charging handle and scraping the finish from the upper or lower when it hits them . . any tips? Should I replace the pin, or is there some trick I can try?

I tried putting some blue loc-tite on the pinhat
Link Posted: 3/19/2006 8:37:55 PM EDT
I always keep spare roll pins for just this reason.......... they can get compressed and it is just easier to replace them.......then to try gimicks with them.

I have a spare roll pin for every one listed in the AR15

JF.
Top Top