Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
Member Login

Site Notices
10/30/2020 2:42:12 PM
Posted: 12/30/2003 3:22:53 PM EST
has anyone seen or used a Redi-Mag? a device attached to the side of the mag well that holds a loaded mag. it's made for a .223. What holds the mag is an arm that locks into the mag release cut on a mag. So would a sten mag work?take a look and see at this site www.odspec.com. Thanks
Link Posted: 12/30/2003 6:06:32 PM EST
It could be done but you would have to pin a set of blocks in if using the sten mag conversion system tacked above, but if using the oly system it should work fine since the 'block' is welded to the mag.
Link Posted: 12/30/2003 8:13:54 PM EST
Originally Posted By 4gma:
It could be done but you would have to pin a set of blocks in if using the sten mag conversion system tacked above, but if using the oly system it should work fine since the 'block' is welded to the mag.
View Quote


Diddo....
Link Posted: 12/31/2003 1:17:53 AM EST
thanks guys
Top Top