Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 5/19/2005 6:46:45 PM EST
bushmaster dissys gas block?
Link Posted: 5/19/2005 7:07:52 PM EST
[Last Edit: 5/19/2005 7:08:06 PM EST by exocet]
not sure..u might have to go with the Larue gas block
Link Posted: 5/19/2005 11:17:56 PM EST
i dont think so unless you grind it down a lot more
Link Posted: 5/20/2005 3:15:43 AM EST
No. The receiver end of the tube is cut so that it will only fit over very low profile gas blocks, like the LaRue gas block. You would not be able to slide the tube over the gas block with the gas block installed OR you wouldn't be able to install the gas block with the tube on (nearly impossible to drive taper pins in with an aluminum tube in the way).
Top Top