Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
BCM
Member Login

Site Notices
10/30/2020 2:42:12 PM
Posted: 12/22/2003 9:09:40 AM EDT
I recently purchased a lower that my bolt catch and mag release button won't fit in.  Should I trade it in or try to sand and file until they fit?  I spoke with the company that I bought it from and they will trade it out, but I would have to wait until this weekend.  I had read many posts on this board about this brand and company and they were pretty much all positive.  
Link Posted: 12/22/2003 10:50:55 AM EDT
Send it back and get it replaced. Unless you bought it with the knowledge that it had to be "re-worked" and you paid accordingly, you got taken. If it is not in spec. there, where else is it out of spec.? And, I bet the minute you "modify" it with a file and/or sandpaper, you will be shit out of luck with the manufacturer as far as fixing it or replacing it.
Link Posted: 12/23/2003 5:06:24 AM EDT
Who made the lower?
Link Posted: 12/23/2003 8:33:39 AM EDT
I'd rather not say.  I don't want to ruin anyone's rep over this.  The company said they will trade it out, so I'll just wait til Saturday.
Link Posted: 12/23/2003 3:20:58 PM EDT
who made the parts?  
Link Posted: 12/24/2003 4:26:02 AM EDT
Always modify the two dollar part.....

-- Chuck
Top Top