Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 12/30/2005 6:47:51 AM EST
[Last Edit: 12/30/2005 6:48:19 AM EST by 20rdMag]








The case had been reloaded 5 or 6 times by me.

21gr of reloader 7 each time.
Link Posted: 12/30/2005 6:50:06 AM EST
I should have also included the following -

The case separated while using a Rock River AR15 M4 (14.5" barrel). I have no way of saying what AR15 the case was used in before the the case separation happened. It could have been any of the following -

BM - Car 16"
EA - M4 16" (BM upper)
BM - Varminter 24"

This is the first time I have had it happen to me. A broken shell extractor was not needed to remove it.
Link Posted: 12/30/2005 6:53:12 AM EST
time to give them a rest?
Link Posted: 12/30/2005 6:56:16 AM EST
I was thinking maybe some duct-tape or JB weld the the case would be good to go.




Link Posted: 12/30/2005 7:41:04 AM EST
time to get new cases
Link Posted: 12/30/2005 7:52:01 AM EST
5-6 times? WOW
Link Posted: 12/30/2005 7:55:44 AM EST
What kind of casing is that? I have some of those.................


I never got around to ask, but now is a good time............
Link Posted: 12/30/2005 8:50:55 AM EST
Lake City 1991

Sounds like you got good use out of the brass. Time to dispose that lot of brass.
Link Posted: 12/30/2005 5:16:30 PM EST
I kinda thought that I would gety more than 5 reloads out of the brass. I will will at the rest of my 91 Lake City brass.
Link Posted: 12/30/2005 7:00:07 PM EST
Time to check some of its brothers and sisters for a bright ring around the case at about the same height. If you are using a small base sizing die (as is highly recommended for reloading rounds for a semi-auto), this is not uncommon since the case base is sized a fraction more than if using standard sizing die. This allows just a RCH more expansion on firing.

The extra working hardens the brass and...
WYSIWYG.
Top Top